Table of Contents
Advertisement
3gb66016.fm Page 17 Monday, August 19, 2002 11:59 AM
ELECTRICAL CONNECTION
• The installer is responsible for the correct electrical
connection of the appliance and the observance of the
relative safety precautions.
• The appliance must be connected to the mains, checking first
that the voltage corresponds to the value given on the rating
plate and that the section of the electrical wires can take the
load indicated on the rating plate.
• The plug must be put into a socket connected to the earth
system in compliance with safety rules.
• If the appliance is supplied without a plug fit a standard plug
which is suitable for the power absorbed by the appliance. Do
not use multiple plug adapters or extension cables.
• The connection can be made directly to the mains by means
of an all-pole disconnect switch with minimum contact gap
of 3 mm.
• When the appliance is installed, the switch or socket must
always be accessible.
• The supply cable must not come in contact with hot parts and
must be positioned so that it does not exceed the
temperature of 75°C at any point.
• After the appliance has been installed, the electrical
components must be inaccessible.
- No liability for damage or injury to persons or property will be
accepted from the non-observance of these requirements.
The appliance must be connected to the earth. The
manufacturer declines all responsibility for any problem
caused by failure to observe this rule.
Replacing the supply cable
Connect the new supply cable, of suitable size and section, to
the terminal board, following the diagrams below:
Use cables type H05V2V2-F resistant to a temperature of 90°C.
230 V~ 50/60 Hz 3 x 0,75 mm
2
.
17
Advertisement
Table of Contents
