Mounting Cabinet/Door Alignment - HandyTrac Key Control Easy Manual Installation And Operation

Here's a summary of the steps to install your System
Familiarize yourself with these steps before you start!
1) Mount the Cabinet on the wall
2) Mount the Control Box and Datalog-Keypad on the wall
3) Insert Key Panels
Cabinet Installation Instructions
1) Find a stud- align stud with at least one of
the six drilled stud holes at the top of the
cabinet. We strongly recommend attaching
the cabinet to a stud, if possible.
2) Stack box cabinet came in and box that
control box came in on top of each other.
3) This will give you a platform 42" high.
4) Place cabinet on top of these two boxes and
a level on top of cabinet.
5) Upon leveling the cabinet, use a pencil to
mark your holes.
6) When all holes are marked, use screws that
penetrate at least 2 inches into stud and wall
anchors that are capable of holding at least 50
lbs. Follow the manufacturer's directions for
wall anchors.
7) Mount Cabinet- Lift the cabinet into place.
Tighten all fasteners snug, but not too tight.
Place your level on top of the cabinet and check
repeatedly as you tighten all of the fasteners.
Door Alignment
Check the gap between door and door frame at the
top, bottom and side. If gap is not uniform all the
way around, the cabinet will have to be shimmed
to compensate for the uneven wall surface. Tips
when shimming:
1) Use metal or plastic-wood and rubber
don't hold their shape well.
2) If gap at top is greater than gap at bottom,
shim top of cabinet at the right hand corner.
3) If gap at bottom is greater than gap at top,
shim bottom of cabinet at the right hand
corner.
4