History Values; Resetting The Controller And System Selection (U1 To U4) - Pentair Riversoft Installer Manual

5.11. History values

The controller features a review level that displays the operation history of the system. To access
history values :
A Press and hold
→ To view the "H" levels.
B Press to navigate through the table.
→ When the desired code is reached, press
value.
→ Some of the values have four digits. Press
first two digits, then press
Note
After 30 seconds without a button press, the controller exists the history table.
Code
H1 Days since last regeneration
H2 Current day of week
H3 Water used today since 02h00
H4 Water used since last regeneration
A0 Average water usage for day 0
A1 Average water usage for day 1
A2 Average water usage for day 2
A3 Average water usage for day 3
A4 Average water usage for day 4
A5 Average water usage for day 5
A6 Average water usage for day 6

5.12. Resetting the controller and system selection (u1 to u4)

All programmed settings with the exception of time of day can be reset. Entering the value "0" will
reset the flash memory to the factory default.
To reset the controller:
A Press and hold
→ A small "u" will be displayed in the left digit.
→ The right digit will display the current system setting.
B Press until the "u0" system is displayed.
→ Wait 5 seconds for the setting to be stored into the flash
memory. The display will return to the time of day.
→ The controller has now system 1 setting (default setting).
C Follow the steps of the system selection procedure to select
the desired system setting (5.9. System selection, page 48).
Ref. MKT-IM-045 / A - 13.03.2020
and simultaneously for 3 seconds.
to display the last two digits.
Description
and simultaneously for 3 seconds.
Installer Manual Riversoft - Programming
to display the
to display the
Days since last regeneration.
0-6.
In liter.
In liters,
max value displayed 9999,
max value stored 65 535.
Notes
49 / 90