Page 1
IMER U.S.A. inc. MORTAR MIXER MIX 60 PLUS 1193981 ( 115 V - 60 Hz ) INSTRUCTION MANUAL IMER U.S.A. Inc. Part. number 3233158 R02 - 2018/09 221 Westhampton Place Capitol Heights, MD 20743 Machine serial N° Ph / 800.275.5463...
Page 2
Thank you for purchasing a mortar mixer MIX 60 PLUS from an IMER U.S.A. dealer. Your decision is an intelligent one. No other mixer in the world today offers the features and value of the MIX 60 PLUS * After the initial set-up the Mixer can be knocked down or reassembled in just minutes.
IMER U.S.A. Inc. MIX 60 PLUS TECHNICAL DATA Fig. 1 HANDLE SAFETY GRID FRAME REDUCTION UNIT SUPPORT BLADE ASSEMBLY TANK HOUSING GEARMOTOR LEGS TANK LIMIT SWITCH DATA PLATE TANK BRACKET WHEEL ELECTRICAL PANEL TECHNICAL SPECIFICATIONS gal (liter) 15 (56) Drum capacity...
- Ensure that mains voltage and cable sizes correspond to specifications. - MIX 60 PLUS is fitted with an ac motor which must be connected - MAKE SURE THAT SIGNS ARE LEGIBLE. to a 115 V power supply with a cable fitted with suitable wear- - It is strictly forbidden to carry out any form of modifi- resistant, anti-crushing and weatherproof sheathing.
California proposition 65 message The IMER MIX 60 PLUS is designed for minimum maintenance requirements. However, we recommend changing the reduction unit Some dust created by power sanding, sawing, grinding, drilling, and oil after 3000 hours continuous duty with SAE 40 oil.
IMER U.S.A. Inc. MIX 60 PLUS WIRING DIAGRAM 115 V 60 Hz U< SWITCH LIMIT SWITCH MOTOR TEMPERATURE SENSOR CAPACITOR EARTH WIRE NEUTRL WIRE PHASE WIRE AM MOTOR RUN WINDING MOTOR START-UP WINDING Fig.3 Fig.2 Fig.4...
SPARE PARTS All orders for spare parts must include the following: 1) Type of machine. (Example: MIX 60 PLUS mixer) 2) Part number and drawing references of each part, see the parts list. 3) Serial number and year of manufacture recorded on the machine's identification plate.
20743 Ph / 800.275.5463 We warrant to the original purchaser that the IMER equipment described herein (the "equipment") shall be free from defects in material and workmanship under normal use and service for which it was intended for period of one (1) year from the date of purchase by the original purchaser.