Connecting Subordinate Devices Via Web-Based Interface - D-Link DIR-825 User Manual

DIR-825 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Gigabit Router with 3G/LTE Support and USB Port
User Manual

Connecting Subordinate Devices via Web-based Interface

To connect a subordinate device with the ESTABLISH CONNECTION button in the web-based
interface, follow the next steps:
1. Simultaneously press the ESTABLISH CONNECTION button in the web-based interface
the main and the subordinate device (or two subordinate devices, if one of them has
previously been connected to the mesh network).
!
Do not press the button on more than two devices simultaneously.
2. The WLAN 2.4G and WLAN 5G LEDs should start blinking one at a time. Wait for about
4 minutes for the subordinate device to receive all mesh network settings from the main
device, including SSID and password.
3. Make sure the connection is successful. To do this, in the web-based interface of the main
device, on the Functions / Wi-Fi / EasyMesh page, in the Network topology section,
check the information on the connected devices.
To view detailed data on a mesh network device, click the line corresponding to this device in the
Network topology section.
Figure 145. The device information page.
Page 181 of 244
Configuring via Web-based Interface