Creating Pptp, L2Tp, Or L2Tp Over Ipsec Wan Connection - D-Link DIR-825 User Manual
Ac1200 wave 2 mu-mimo wi-fi easymesh gigabit router with 3g/lte support and usb port
Hide thumbs
Also See for DIR-825:
- User manual (249 pages) ,
- Quick installation manual (61 pages) ,
- Configuring (20 pages)
Table of Contents
Advertisement
DIR-825 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Gigabit Router with 3G/LTE Support and USB Port
User Manual
Creating PPTP, L2TP, or L2TP over IPsec WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 74. The page for creating a new PPTP connection. The General Settings section.
Parameter
Connection name
Enable connection
NAT
Ping
General Settings
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Page 90 of 244
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
