Table of Contents
Advertisement
Quick Links
The AMC1311 is a precision isolation amplifier with an output separated from the input circuitry by a
silicon dioxide (SiO2) barrier that is highly resistant to magnetic interference. This barrier has been
certified to provide reinforced galvanic isolation of up to 7000 V
0884-11): 2017-01.
...................................................................................................................
1
1.1
2
2.1
2.2
2.3
3
3.1
3.2
4
4.1
4.2
4.3
5
6
6.1
6.2
7
1
2
...................................................................................................................
3
VDD1 Input
4
5
6
1
2
3
4
5
6
Bill of Materials
SLAU745 - November 2017
Submit Documentation Feedback
..............................................................................................................
..............................................................................................................
.........................................................................................................
............................................................................................................
.......................................................................................................
..............................................................................................................
..........................................................................................................
..........................................................................................................
...............................................................................................................
...................................................................................................
.................................................................................................................
............................................................................................
......................................................................................................
............................................................................................................
.....................................................................................................
......................................................................................................
............................................................................................
..................................................................................................
............................................................................................................
............................................................................................................
............................................................................................
............................................................................................................
.........................................................................................
...............................................................................................................
Copyright © 2017, Texas Instruments Incorporated
AMC1311EVM Users Guide
per DIN V VDE V 0884-11 (VDE V
PEAK
Contents
..................................................................
................................................................
List of Figures
......................................................................
...................................................................
List of Tables
User's Guide
SLAU745 - November 2017
AMC1311EVM Users Guide
2
2
2
2
3
3
4
4
4
5
5
5
6
6
7
7
8
9
2
3
4
4
6
8
5
5
5
5
6
7
1
Advertisement
Table of Contents
Related Manuals for Texas Instruments AMC1311EVM
Summary of Contents for Texas Instruments AMC1311EVM
-
Page 1: Table Of Contents
Schematic and Bill of Materials ...................... Bill of Materials ......................Schematic ..................... Related Documentation List of Figures ..............AMC1311EVM Schematic – Analog Input Section ..............AMC1311EVM Schematic – Analog Output Section ........................VDD1 Input ...................... VDD2 Input Connector .................... AMC1311 Silk Screen Drawing .................... -
Page 2: Introduction
J1.2 or TP2. Analog Input The default analog input to the AMC1311EVM board is comprised of R4 and C3 which form a simple anti- aliasing filter with a corner frequency of 723 Hz. The input circuit for the AMC1311 is shown in Figure Using a signal generator or other voltage source, the user can apply an input signal directly to J1 pin 1. -
Page 3: Shutdown
SH-J7 is removed. Analog Output The analog output from the AMC1311EVM board is a fully differential signal centered at 1.44 V. The differential output of U1 is available on the two screw terminals of J2 as shown below in Figure 2. -
Page 4: Power Supplies
Power Supplies www.ti.com Power Supplies The AMC1311EVM requires two separate power rails, VDD1 and VDD2. VDD1 is on the high voltage side of the amplifier. VDD2 is on the user side of the amplifier. VDD1 Input The default configuration of the EVM provides 5V to VDD1 through transformer T1 via U3, an SN6501 push-pull driver. -
Page 5: Evm Operation
J2.2 VOUTP Inverting output from the AMC1311 (pin 7). The VDD2 power input to the AMC1311EVM printed circuit board can be applied directly to J3 pins 1 and Table 4 lists the details of J3. Table 4. J3 – VDD2 Power... -
Page 6: Device Operation
Ground reference. Device Operation Once the VDD1 and VDD2 power is applied to the AMC1311EVM, the analog output will be available with a fixed gain of one and a DC offset equal to 1.44 V (typical). An analog input signal may be applied directly at screw terminal J2. Refer to... -
Page 7: Schematic And Bill Of Materials
Schematic and Bill of Materials www.ti.com Schematic and Bill of Materials This section contains the complete bill of materials, and schematic diagram of the AMC1311EVM. Bill of Materials Table 6. Bill of Materials Designator Description Manufacturer Mfg. Part Number C1, C6 CAP, CERM, 0.1 µF, 50 V,+/- 10%, X7R, 1206... -
Page 8: Schematic
U2 TLV70450DBVT GND2 VDD1 GND1 10µF 10µF 10µF SH-J5 0.1µF GND1 SN6501DBVR GND1 GND2 GND1 Copyright © 2017, Texas Instruments Incorporated Figure 6. AMC1311EVM Schematic AMC1311EVM Users Guide SLAU745 – November 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 9: Related Documentation
Related Documentation To obtain a copy of any of the following TI documents, call the Texas Instruments Literature Response Center at (800) 477-8924 or the Product Information Center (PIC) at (972) 644-5580. When ordering, please identify this booklet by its title and literature number. Updated documents can also be obtained through our website at www.ti.com/. - Page 10 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
- Page 11 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 12 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿６丁目２４番１号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧ください。http:/ /www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 3.4 European Union 3.4.1 For EVMs subject to EU Directive 2014/30/EU (Electromagnetic Compatibility Directive): This is a class A product intended for use in environments other than domestic environments that are connected to a low-voltage power-supply network that supplies buildings used for domestic purposes.
- Page 13 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2017, Texas Instruments Incorporated...
- Page 14 IMPORTANT NOTICE FOR TI DESIGN INFORMATION AND RESOURCES Texas Instruments Incorporated (‘TI”) technical, application or other design advice, services or information, including, but not limited to, reference designs and materials relating to evaluation modules, (collectively, “TI Resources”) are intended to assist designers who are developing applications that incorporate TI products;...
- Page 15 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments AMC1311EVM...
Need help?
Do you have a question about the AMC1311EVM and is the answer not in the manual?
Questions and answers