Table of Contents
Advertisement
Reinstallation
7. Remove the actuator from the valve.
Also remove the adapter set if you do not re-
quire it any longer for this valve.
10. Reinstallation
The actuator must not be in the lower stroke
position for correct installation.
1. Connect the power supply.
Z The internal energy store will be charged.
2. After about 3.5 seconds, move the actuator to
an upper to mid stroke position with the help of a
control signal.
3. Install the actuator as described in section5.
4. Put the actuator into operation as described in
section 6.
5. Trigger an initialisation run by actuating DIP switch
6 (see Illust. 4).
Z The actuator is ready for operation.
10
Electromotive actuator 24 V
11. Disposal
Guideline 2012/19/EU WEEE:
Waste electrical and electronic equipment
(WEEE) must not be disposed of with do-
mestic waste, but must be dropped off at a
collection point for the recycling of electri-
cal and electronic appliances.
NOTICE
Risk of environmental pollution
Incorrect disposal (for instance with the
domestic waste) may lead to environmental
damage.
f Packaging material is to be disposed of in
an environmentally friendly manner.
f Components are to be disposed of pro-
fessionally.
If no return or disposal agreement has been made,
the product has to be disposed of.
f If possible, the components are to be recycled.
f Components, which cannot be recycled, are to be
disposed of according to the local regulations. Dis-
posal with the domestic waste is inadmissible.
115801384-V01.01.2020
Advertisement
Table of Contents
