Rockwell Automation Allen-Bradley ControlLogix 1756-MVI Programming Reference Manual page 16

1-6 1756-MVI Module Overview
|
|
+---------------------------------------------------------------+
|
|
|
|
|
|
|
|
+---------------------------------------------------------------+
|
Publication 1756-RM004B-EN-P - October 2000
TIP
Figure 1.4 shows the boot messages displayed on the console after
power-on:
General Software 80C386-EX Embedded BIOS (tm) Version 4.1
Copyright (C) 1998 General Software, Inc.
1756-MVI Multi-Vendor Interface Module
MVI BIOS v1.00
Copyright (c) 1999-2000 Online Development, Inc.
Hit ^C if you want to run SETUP.
Type Ctrl-C to if you want to open the BIOS Setup Main Menu
(figure 1.5).
System Bios Setup - Utility v4.001
(C) 1998 General Software, Inc. All rights reserved
MVI Module Configuration
Begin Flash ROM Update Mode
Reset Configuration to Factory Default
The BIOS Setup Main Menu contains the three items shown above.
To move from one menu item to another, press Tab. To select the
current item, press Enter. To exit the Main Menu and continue
booting, press Esc or choose Exit.
If the 1756-MVI module boot messages do not
appear on the console terminal when the module is
powered on, check the position of the Setup Jumper
(see the Installation Instructions). In Setup Mode
(setup jumper installed), the console port will be
enabled and configured for 19200 baud, no parity, 8
data bits, and 1 stop bit.
Figure 1.4 Power-On Boot Messages
Figure 1.5 BIOS Setup Main Menu
Exit
<Esc> to continue
|
|
|
|
|
|
|
|
|
|
|