To Remove/Replace Comfort Lining - Arai Defiant-X Operation Instructions Manual

①
ホック
④
L システム内装の着脱
枠
Image
Image
それぞれのホックを引っぱる向き
取り出したシステム内装は、折り癖がつ
かないように広げておいて ください。
② ③
⑤ ⑥
ホック
枠
English

TO REMOVE/REPLACE COMFORT LINING

The comfort lining is secured to the helmet by plastic bosses ①.
To remove the lining, undo bosses by grasping the lining as close to each boss
as possible ② and pulling straight up ③. Note the fore & back, top & bottom
sides of the lining for replacement.
To wash the comfort lining, put it into lukewarm water with small amount of laundry
soap or your own shampoo and wash gently by hand. Rinse well with fresh water
and wipe off with a soft cloth. Dry it in the shade at ambient temperature.
WARNING : Never use petrol, thinner, benzene or any other solvents.
To replace the lining, place the bosses over their plastic receptacles and push
them home ④,⑤ & ⑥.
WARNING :
When reinstalling the comfort lining, be sure the lining is
properly positioned along the inside shape of the EPS (a.k.a. Styrofoam)
liner. If the comfort lining is not properly installed, the frame of the comfort
lining may fold when you put on and take off the helmet, which may injure
your skin, etc. Whenever you feel something is wrong with the comfort
lining, check that the lining is properly installed.
9