Monte Carlo Fan Company 5LNR52 D-L Series Owner's Manual page 4

19
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet bo x.
22
Attached light fixture onto the plate,
aligning its keyhole slots with the
screws on the plate. Twist clockwise
till lock. Re-install the screw removed
in step 21. Tighten all screws secure-
ly.
25
Install the 3 x 40 watt incandescent candelabra
bulbs. Bulbs included.
WaRnInG: over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed. Reset the lights by turning off
the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
28
Place light kit cover over frame with
the glass aligning the 3 holes. Install
and secure the 3 screws.
20
Loosen one and remove one preassem-
bled screw from mounting bracket.
Save screw. Lift canopy up, aligning its
keyhole slot with the preassembled
screw on mounting bracket and twist
clockwise to lock in place. Re-install the
removed screw and tighten all screws
securely.
23
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
26
Loosen 3 set screws. Place glass into
frame and tighten 3 set screws
securely.
29
Raise glass with the frame up to the
light kit socket assembly aligning 3
pertruding nipples. Twist counter
clockwise to lock into place. Be sure
that the glass and frame goes all the
way up to the motor.
21
Loosen 2 screws and remo ve 1
screw. Save screw removed.
24
Loosen 2 screws and remove 1 screw
from light fixture.
Attached heat shield onto light fixture,
aligning its keyhole slots with the screws
on light fixture and twist into place. Re-
install the screw removed and tighten all
screws securely.
27
Remove 3 screws from the fr ame with the
glass. Save these screws.
30
Reverse function for this fan is a
switch on top housing of the fan
body. Turn fan off and flip switch,
this will reverse the direction of the
blades.