Monte Carlo Fan Company 5LNR52 D-L Series Owner's Manual page 3

7
Remove upper motor housing.
10
Align the 6 holes on the y oke and
replace with the screws sa ved from
earlier step. Tighten securely.
13
Tighten 2 downrod set screws and
lock nuts.
16
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter . If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
8
Place blades in the side slots of the
motor. Line up the 3 holes and install
washers and screws securely.
11
Slide canopy and yoke cover onto the
downrod. Thread the leadwires and
safety cable through the downrod as
shown.
14
Raise fan with downrod assembled to
the ceiling bracket and hang fan
assembly. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
17
Install remote receiver by sliding into opening in
the Mounting bracket. Make sure that the dip
switches on the Transmitter and the Receiver
are set to the same position.
9
Replace upper motor housing.
12
Align hole in downrod with hole in
yoke and install cross pin. Install
downrod into yoke. Install keeper
into cross pin.
Safety cable installation
15
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
Fan and light kit combinations o ver 35 lbs,
in both flush and downrod mode the safet y
cable must be installed into the house struc -
ture beams using the 3" lag screws,w ashers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
18
white
black
Make wiring connections as indicated abo ve.
White from fan to white from remote mark ed
N. Blue from fan to blue from remote mark ed
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.