Included in some kits (see carton for
kits inclusions). Can be purchased
seprately.
Connecting
Pressure
Pipework
Limiting Valve
Isolation
Valve
Copyright © Puretec Pty Ltd 2019
Important: Sales of products are subject to our Terms & Conditions which are
available upon request. All specifications, prices and photos are a guide only
and are subject to change without notice. Please ring to confirm details. Do not
use products with microbiological unsafe water without adequate disinfection.
If incoming water pressure exceeds 350kPa for FP10T and 875kPa for all other
housings, a pressure limiting valve must be fitted prior to inlet. Maximum flow
depends on cartridges, vessel, pressure, impurities etc.
WARRANTY
Any claim under this warranty must be made within 10 years of the date of
purchase of the product. This product is warrantied to be free of defect of
material and workmanship for 10 years from date of purchase. 10 year warranty
is 1 year parts and labour, plus 9 years parts only. Excludes consumables. 10 year
warranty applies to FP10B, FP10M, FP20B and FP20M. All other housings carry a
3 year parts warranty. To make a claim under the warranty, take the product and
proof of purchase to place where you purchased the product, and they will lodge
a Warranty Request with Puretec.
Puretec will pay your reasonable, direct expenses of claiming under this warranty.
You may submit details and proof of your expense claim to place of purchase for
consideration.
The warranty only applies if the product was used and/or installed in accordance
with the user guide and/or installation instructions. This warranty is given in
lieu of all other express or implied warranties and manufacturer shall in no
circumstance be held liable for damages consequential or otherwise or delays
caused or faulty manufacturing except as excluded by law.
Applicable to all above, is that the warranties need to be approved by Puretec to
ensure product was not incorrectly used, installed or claimed. False and incorrect
claims will be pursued at Puretec's discretion, including chargeable inspection and
labour costs incurred.
Warranty Australia
This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie
Road, Lonsdale SA 5160, telephone no. 1300 140 140 and email at sales@
puretec.com.au.
This warranty is provided in addition to other rights and remedies you have
under law: Our goods come with guarantees which cannot be excluded under the
Australian Consumer Law. You are entitled to replacement or refund for a major
failure and to compensation for other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
Warranty New Zealand
This warranty is given by Puretec Ltd, Reg. No 4464398, Level 2, Onehunga Mall,
Auckland 1061, tel. no. 0800 130 140 and email at sales@puretec.co.nz.
Housing Assembly
(single pictutred)
This warranty is provided in addition to other rights and remedies you have
under law: Our goods come with guarantees which cannot be excluded under the
Consumer Guarantees Act. You are entitled to replacement or refund for a major
failure and to compensation for other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
User Guide
Heavy Duty Filter Housing
For correct operation & installation it is
FEB2019
essential to observe these instructions.
FP Series
Need help?
Do you have a question about the FP Series and is the answer not in the manual?
Questions and answers