Table of Contents
Advertisement
Installation Without Base
Lap Belt Installation
•
Figure A illustrates a typical rear facing lap
belt installation of restraint only.
WARNING:
Do not install this restraint using
a non-locking ELR vehicle belt, unless a
belt shortening clip is used. Refer to the
vehicle owner's manual for instructions
on correct use of vehicle belts with child
restraints.
1
Place the restraint rear facing on the
vehicle seat.
2
Push cover back to expose belt guides
(Fig. B).
3
Pull to fully extend vehicle belt.
4
Route vehicle belt under both belt guides.
5
Verify that the vehicle belt is not twisted,
then buckle.
•
When correctly reclined, the red line on
restraint will be level with the ground.
•
If there is a problem stabilizing the restraint, place a rolled towel in the crease of
the vehicle seat to help level the restraint.
WARNING:
Only raise restraint as described above. Do not raise the
restraint off of the front edge of vehicle seat; doing so will reduce
the protection for your child.
6
Push the restraint firmly into the vehicle seat while removing slack
from the vehicle belt.
7
Adjust handle to In-Vehicle position.
8
Verify that vehicle belt is tight and that the restraint is stable.
28
A
B
This child restraint is certified for use in
aircraft. Most airlines in the U.S. and
Canada will allow the use of a child
restraint, if it is labeled as an approved
child restraint for airline use and fits
properly on the plane. Contact the airline
about their policy prior to traveling.
• Place the restraint next to a window
to avoid blocking the aisle.
• If the aircraft lap belt is too short, ask the flight attendant for
a Belt Extender.
T T o o I I n n s s t t a a l l l l i i n n A A i i r r c c r r a a f f t t : :
1
Place the restraint, without base, rear facing on the aircraft seat.
2
Push cover back to expose belt guides.
3
Fully extend aircraft lap belt.
4
Route aircraft belt under each belt guide.
5
Verify that the seat belt is not twisted, then buckle.
6
Push the restraint firmly into the seat while removing slack from the
seat belt.
7
Verify that vehicle belt is tight and that the restraint is stable.
Installation in Aircraft
C
29
Advertisement
Table of Contents
