Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Britax Y2K 03.A
Summary of Contents for Britax Y2K 03.A
- Page 1 03.A teutonia-Y2K 03.A User Guide User Guide...
- Page 2 T h i s p r o d u c t a n d i t s c o m p o n e n t s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e . ©...
-
Page 3: Table Of Contents
Table of Contents Introduction ..... 2 Safety Information ....3 Initial Assembly . -
Page 4: Introduction
Introduction Congratulations! Our slogan, "Babys first friend" is our philosophy. teutonia products combine traditional workmanship and technical innovations with fashionable design. The name teutonia stands for quality that meets the most stringent requirements. The embroidered teutonia logo and the rainbow on the handle are your guarantees that this is an original teutonia model. -
Page 5: Safety Information
Safety Information A child´s safety is your responsibility. Read these instructions carefully before using your stroller. Save this user guide for future reference. It is important that these instructions are understood and followed by any person who will use this stroller. •... -
Page 6: Initial Assembly
Initial Assembly Installing the Wheels: To install the rear wheels, depress the locking spring (A-1) and slide the wheel onto the axle (A-2). Release the locking spring, then pull to verify that the wheel has locked in place. To install the front wheels, align the bearings with the slots (B-1) on the end of the stroller frame, then push (B-2) to attach. -
Page 7: Initial Assembly
Initial Assembly Installing the Bumper Bar: Insert the bumper bar support rods into the slots on the armrests until locked in place (C-1). Installing the Seat Pad: Unfasten all harness clips (D-1). Place seat pad on seat unit, aligned so that the attachment clips are near the headrest area. -
Page 8: Operating Instructions
Operating Instructions Unfolding the Stroller: In one movement, pull the handle (E-1) up as far as it will go until both ends of the handle engage in the plastic housings (E-2) on each side. Verify that each handle end has fully engaged, with a positive click, into the locked position. -
Page 9: Using The Five-Point Harness
Operating Instructions Using the Five-Point Harness: Open the harness by pressing both sides of the buckle latches as shown in figure H. It is not necessary to disconnect the shoulder straps from the waist straps. Sit your child in the stroller with one leg on either side of the crotch strap. -
Page 10: Adjusting Handle Height
Operating Instructions Adjusting Handle Height: To adjust the height of the handle, press and hold both reflectors (K-1) while adjusting the height of the handle to the desired position (K-2). Release reflectors when desired position is achieved, to lock handle in place. Reversing the Seat Unit: To remove the seat unit, press the locks (L-3) down until the unit is released. -
Page 11: Using The Footrest
Operating Instructions Using the Footrest: The position of the footrest can be adjusted by raising the footrest and letting the support bar engage in the desired rung. IMPORTANT: There is a red safety hook on the footrest. When the footrest is raised to a horizontal position, this hook must be pushed onto the support bar to lock it into place. -
Page 12: Installing & Removing The Wheels
Operating Instructions Installing and Removing the Wheels : To install the wheels, depress the locking spring and slide the wheel onto the axle. Release the locking spring and make sure the wheel has locked in place. To remove the wheels, press the locking spring/clip (O-1 & P-1) and slide the wheel from the rear axle (O-2) or front fork (P-2). -
Page 13: Warranty
The warranty and remedies as set forth above are exclusive and in lieu of all others, oral or written, express or implied. In no event will Britax, or the retailer selling this product, be liable for any damages, including incidental or consequential damages, arising out of the use or inability to use this product.