Water Softener; Adjusting Salt Consumption - Scandomestic SFO 3502 W User Manual

Water Softener

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.

Adjusting salt consumption

The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in salt consumption.
1 Close the door and Switch on the appliance;
2 Press the Rapid button for more than 5 seconds to start the water softener set model
within 60 seconds after the appliance was switched on;
3 Press the Rapid button to select the proper set according to your local environment, the
sets will change in the following sequence:
H3->H4->H5->H6->H1->H2->H3;
Without operation in 5 seconds or press the Power button to complete the setup and exit
the setup mode.
WATER HARDNESS
German Frenc
dH h fH
0 - 5 0 - 9
6 - 11 10 -
20
12 - 17 21 -
30
18 - 22 31 -
40
23 - 34 41 -
60
35 - 55 61 -
98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l The manufactory setting: H3
Contact your local water board for information on the hardness of your water supply.
British Mmol/l
Clarke
0 - 6 0 - 0.94
7 - 14 1.0 - 2.0
15 - 21 2.1 - 3.0
22 - 28 3.1 - 4.0
29 - 42 4.1 - 6.0
43 - 69 6.1 - 9.8
Water softener level
H1-> Rapid Light bright
H2-> 90 min Light bright
H3-> 90 min, Rapid Light
bright
H4-> Glass Light bright
H5-> Glass, Rapid Light
bright
H6-> Glass, 90 min Light
bright
Salt
consumption
(gram/cycle)
0
9
12
20
30
60