Troubleshooting Tips - Scandomestic SFO 3502 W User Manual

TROUBLESHOOTING TIPS

Problem
Technical Dishwasher
problems will not
start
The water
is not
pumped
out
Almindelige Suds in the
problemer tub
Sained tub
interior
White film
on inside
sufface
Rust on the
cutlery
Noise Knocking
noise
Rattling
noise
Caurse
Fuse blown, or the
circuit breaker tripped
Power supply is not
turned on
Door of dishwasher
not properly closed .
Kink in drain hose
Filter clogged.
Kitchen sink clogged.
Improper detergent
Spilled rinse-aid
Detergent with
colourant was used
Hard water minerals
The affected items are
not corrosion
resistant.
A programme was not
run after dishwasher
salt was added. Traces
of salt have got into
the wash cycle.
The lid of softer is
loose.
The spray arm is
knocking against an
item in a basket.
Item of crockery are
loose in the wash
cabinet
Solutions
Replace fuse or reset circuit breaker. Remove any
other appliances sharing the same circuit with the
dishwasher
Make sure the dishwasher is turned on and the door
is closed securely.
Make sure the power cord is properly plugged into
the wall socket.
Make sure to close the door properly and latch it.
Clean The Filter
Check kitchen sink to make sure it is draining well.
If the problem is the kitchen sink not draining ,you
may need a
plumber rather than a serviceman for dishwasher.
Use only the special dishwasher detergent to avoid
suds. If this occurred, open the dishwasher and let
suds evaporate. Add 1 gallon of cold water to the
tub. Close and latch the dishwasher, then Start any
wash cycle to drain out the water. Repeat if
necessary.
Always wipe up rinse-aid spills immediately.
Make sure that the detergent is the one without
colourant
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
Always run the Quick wash programme without any
crockery in the dishwasher and without selecting
the Turbo function (if present), after adding
dishwasher salt.
Check the lid. Ensure the fix is fine.
Interrupt the program, and rearrange the items
which are ob- structing the spray arm.
Interrupt the program, and rearrange the items of
crockery.