Water Softener - Scandomestic SFO4201 Instruction Manual

Water Softener

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Switch on the appliance;
2. Press the Start/Pause button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on;
3. Press the Start/Pause button to select the proper set according to your local
environment, the sets will change in the following sequence:
H4->H5->H6->H1->H2->H3;
4. Press the Power button to end the set up model.
WATER HARDNESS
German German French French
dH dH
fH fH
0 - 5 0 - 9
6 - 11 10 - 20
12 - 17 21 - 30
18 - 22 31 - 40
23 - 34 41 - 60
35 - 55 61 - 98
° °
1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
The manufactory setting: H4
Contact your local water board for information on the hardness of your water supply.
British British
Mmol/l Mmol/l
Clarke Clarke
0 - 6 0 - 0.94
7 - 14 1.0 - 2.0
15 - 21 2.1 - 3.0
22 - 28 3.1 - 4.0
29 - 42 4.1 - 6.0
43 - 69 6.1 - 9.8
°
Water softener level Water softener level
H1-> Rapid Light bright
H2-> 90 Min Light bright
H3-> 90 Min, Rapid Light bright
H4-> Glass Light bright
H5-> Glass, Rapid Light bright
H6-> Glass, 90 Min Light bright
6
Salt consumption Salt consumption
(gram/cycle) (gram/cycle)
0
9
12
20
30
60