Table of Contents
Advertisement
10
Introduction
General operating information
Introduction
It is also possible to change stations and adjust volume settings via the multi-
function steering wheel.
Additional information:
•
⇒ page 6
Safety notes
•
Unit overview ⇒ page 8
•
Multi-function steering wheel ⇒ Booklet "Owner's manual"
Caution
Only a small amount of pressure is needed to operate the unit.
Note
•
Never press a button down for longer than 10 minutes. Otherwise the
system will interpret this as a malfunction (button jammed).
•
Due to country-specific legislation, certain functions cannot be selected
on the screen when the vehicle is travelling above a certain speed.
•
The rubber mat in the storage compartment under the radio can be
removed.
•
Using a mobile phone in the vehicle may cause noise from the vehicle
speakers.
•
In some vehicles equipped with a parking distance warning system, the
volume of the current audio source is automatically lowered when reverse
gear is engaged.
Switching on and off
Function
Operation
Switch the unit on or off
Briefly press the rotary/push knob
manually.
The unit switches off automatically roughly
30 minutes after the ignition key is removed
(switch-off delay).
Switch on the unit auto-
Insert the vehicle key into the ignition lock.
matically.
The unit switches on automatically if it was on
when the ignition key was removed.
Switch off the unit auto-
Remove the vehicle key from the ignition lock.
matically.
When the unit is switched on the system starts up. The last audio source used
is played at the last selected volume setting, provided this does not exceed
the preselected "switch-on volume" (ON-VOLUME ⇒ page 29).
Energy management
If, when the ignition is switched off and the unit switched on, the battery
voltage falls below the minimum onboard power supply voltage, a signal
sounds and LOW BATTERY appears. You should switch the radio off.
If the battery voltage level continues to fall, RADIO OFF is briefly displayed
and the radio will switch itself off automatically.
Anti-theft code
The anti-theft coding system code is stored once it has been entered in the
vehicle for the first time (radio convenience coding). The anti-theft code must
be re-entered manually if the unit is fitted in another vehicle (display: first
SAFE and then CODE and 1000). In this case, you should contact a SEAT
dealer.
If the battery has simply been disconnected, the anti-theft code does not
have to be entered by hand.
.
Advertisement
Table of Contents
