Electrical Connection; Maintenance; Special Accessories - Scheppach woova 2.0 Translation From The Original Instruction Manual

Initial operation
Note safety instructions before operation. The data on the
motor type plate (voltage and frequency) must conform to
the mains supply voltage and frequency. After connection
to the mains, the Dust Extractor woova 2.0 is ready for
operation.

Electrical connection

Connection and repair work on the electrical equipment
must be carried out by a qualified technician only.
The installed electric motor is factory connected ready for
operation.
The connection made by the customer as well as any exten-
sion cables used must comply with all relevant regulations.
Importand note
Defective electrical connection cables
Electrical connection cables often suffer isolation damage.
Possible causes are:
• Pinch points when connection cables are run throught
window or door gabs.
• Kinks resulting from incorrect attachment of laying of
the connection cable.
• Cuts resulting from running over the connection cable.
• Isolation damage resulting from forcefully pulling out of
the wall socket.
Such defective electrical connection cables must not be used
as the isolation damage makes them extremly hazardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains when
checking.
Electrical connection cables must comply with the regula-
tions applicable in your country.
One phase motor
• The mains voltage must comply with the specification on
the motor name plate.
• Extension cables must have a cross section of at least
1.0 sqmm.
• The mains is protected by a 16 A slowblow fuse.
When making inquiries please specify the following:
• Motor manufacturer
• Motor current type
• Motor nameplate specifications
• Switch nameplate specifications
When sending the motor in, always send the complete
drive unit including the switch.
8 english

Maintenance

For all maintenance and cleaning tasks, tum off motor
and unplug mains.
• Connection and repair work on the electrical installation
may be carried out by a qualified electrician only.
• For constant performance, periodically shake out filter
bag vigorously. Between cleanings, beating the bag with
the hand several times is sufficient.
• The sawdust bag must be replaced a1 the latest when
the sawdust is within 10 cm. of the housing collar.

Special accessories

Filter bag U/S/G
Filter catridge U/S/G
Disposable sawdust bag, 25pc.
Reusable sawdust bag, 20pc.
Extension coupling
EC Declaration of Conformity
We, scheppach Fabrikation von Holzbearbeitungsmaschinen GmbH,
hereby declare that the machine named below corresponds to the
reievant safety and health requirements
of the EC guidelines specified below in ~ design and construction and
in the version which we introduced to the market.
This declaration becomes invalid if changes are made to the machine
without our consent.
Description of the machines:
Dust extractor
Machine type:
woova 2.0
Relevant EC guidelines:
EC machine directive 2006/42/EG,
EC Low voltage directive 2006/95/EWG,
EC­EMV directive 2004/108/EWG.
Applied harmonized standards, especially:
EN 292­1, EN 292­2, EN 294, EN 349, EN 418, EN1088,EN 60204­1, EN
55014, EN 55104, EN 60555­2,EN 60555­3
Applied national technical standards and specifications, especially:
UW 3.1, UW 3.9,VDE 0530­1/11.72
Date:
Ichenhausen, 07. 01.1997
Signature:
i. v. Reinhold Bauer
Part no. 7508 0010
Part no. 7500 6000
Patr no. 7500 1400
Part no. 7500 1500
Part no. 7500 3300
i.V. Gerhard Bucher