Latch Bar; Lap/Shoulder Belt Installation - Britax Boulevard User Manual

Installation: Forward Facing

Lap/Shoulder Belt Installation

• Figure A illustrates a typical forward-facing lap/
shoulder-belt installation.
• When not in use, always store LATCH connectors
in storage slots.
1 Place child restraint forward facing on
vehicle seat.
• Restraint must be in full upright position
when installed in forward-facing mode with
children over 33 pounds (15 kg.).
• Britax recommends use of Versa-Tether®
to improve installation. Remove Versa-
Tether from pouch and loosely attach to an
approved tether-anchorage point (pg. 24).
2 Pull vehicle belt out, then thread it over
LATCH bar and through the forward-
facing belt path (fig. B).
3 Verify that vehicle belt is not twisted
and is routed over LATCH bars, then
buckle (fig. C).
4 Rotate lever downward to open
forward-facing lock-off farthest from
where vehicle belt will be buckled.
5 Remove slack from lap portion of
vehicle belt.
6 Kneel on child restraint to push it into
vehicle seat while pulling shoulder
portion of vehicle belt tightly through
lock-off (fig. D).
20
A
B
C