Table of Contents
Advertisement
TRAVEL SYSTEM
INTEGRAL LATCH
INSTALLATION INSTRUCTIONS PREPARING THE BABY
CAPSULE - LATCH METHOD
You may need to remove the Britax CLICK & GO™ Adaptors (see page 71 to 73) to
enable fitment on some strollers when using the integral latch system.
A. Remove baby from Baby Capsule.
B. Rotate handle into "carry position", then lift the release catch with the other hand.
C. With the release catch depressed lift the Baby Capsule clear of the base hooks, and
remove from the car.
PREPARING THE STROLLER
A. Ensure the Stroller has been assembled correctly.
B. Open the Stroller, apply the brakes.
C. Before fitting the Baby Capsule check and ensure all latches are engaged to prevent
the stroller folding inadvertently.
D. Lower the backrest to the fully reclined position.
E. Remove the arm bar cover and store in the basket pocket.
* Refer to page 22 for handle position
66
Instructions for Installation & Use
Arm Bar cover removed
INSTALLING THE BABY CAPSULE INTO THE STROLLER -
LATCH METHOD
A. Ensure that the arm bar (or tray) is fully locked in position on both sides of the
armrests.
B. Position the Baby Capsule over the Stroller with the baby's head end of the Baby
Capsule over the Stroller arm bar (or tray).
C. Lower the Baby Capsule and ensure that it locates onto the Arm Bar, (or tray) and
the latches engage.
Latches
Arm Bar
TRAVEL SYSTEM
INTEGRAL LATCH
Arm Bar
Latch
Tray
Instructions for Installation & Use
67
Advertisement
Table of Contents
