Count-Down Function - Silvercrest SPLD 2 A1 Operating Instructions Manual

Count-down function

♦ If the timer 3 is in standby mode, press any button
to switch it on .
The display 5 shows the last used time .
NOTE
► Press the buttons "Min" 7 and "Sec" 4 at the
same time (=reset) to reset the time .
► When the timer 3 has been activated, you will
hear a beep whenever you press a button .
♦ Press the buttons "Min" 7 and "Sec" 4 to set the
time in minutes and seconds . The timer goes up to
99:59 (min/sec) .
Press and hold the button to scroll through the
digits faster .
♦ Press the "Start/Stop" button 6 to start the time
count-down .
NOTE
► You can stop the count-down at any time by
pressing any button . To resume the count-down,
press the "Start/Stop" button 6 .
♦ Once the set time has expired, the product will beep
for approximately 1 minute . After the alarm signal
stops, the display 5 shows the last set time .
After 1 minute, the timer 3 will switch to standby
mode .
NOTE
► You can stop the alarm signal at any time by
pressing any button .
When you press the "Start/Stop" button 6, the
display 5 shows the last set time .
Press the buttons "Min" 7 or "Sec" 4 to reset the
timer 3 to 00:00 .
■ 22 │ GB │ MT
SPLD 2 A1