Specification - TTI TSX Series Service Manual

Output Specifications
Operating modes:
Voltage Range:
Current Range:
Overvoltage protection range:
Setting Resolution:
Load Regulation:
Line Regulation:
Output Impedance:
Ripple and noise:
HF Common mode noise:
Transient load response:
Temperature coefficient:
Overvoltage protection delay:
Protection functions:
Regulator overtemperature:
Status indication:
Output switch:
Output terminals:
Input Specifications
Input voltage range:
Power requirement:
Voltage range selection:
Meter Specifications
Meter types:
Meter resolutions:
Meter accuracies:
Front Panel Controls
Voltage setting:
Current setting:
Overvoltage setting:
Output on/off:
Constant voltage or constant current with automatic crossover.
0V to 35.3V (35V/10A), 0V to 18.15V (18V/20A)
0.01A to 10.2A (35V/10A), 0.01A to 20.2A (18V/20A)
1V to 40V (35V/10A), 1V to 25V (18V/20A)
10mV, 10mA
<0.01% for a 90% load change
<0.01% for a 10% line voltage change
<1mΩ in constant voltage mode,
>5kΩ in constant current mode
<3mA RMS typical in constant current
Typically <3mV RMS, <10mV pk.
<200us to within 50mV of set level for a 90% load change.
Typically <100ppm/ o C
<200us
Overvoltage trip
Sense miswiring
Output on/off LED
Constant voltage mode LED
Constant current mode LED
Trip message
Electronic
4mm output terminals at front
Screw terminals for output and sense at rear
180V to 270V RMS
90V to 135V RMS
47 to 63Hz, 600VA max.
Rear panel slide switch
Separate 4-digit meters for voltage and current with 12.5mm (0.5")
LED displays
10mV, 10mA
Voltage 0.2% ± 1 digit, Current 0.5% ± 1 digit
Direct keyboard entry or quasi-analogue rotary control
Direct keyboard entry or quasi-analogue rotary control
Direct keyboard entry
Push button with dual indicator LEDs

Specification

3