Fuse Replacement; Troubleshooting - Martin Wheeler User Manual

Table of Contents

Advertisement

L A M P O N
In "lamp on" mode, the lamp stays on and drum rotation is sound activated. If
there is no sound, drum rotation stops.
F L A S H
In "flash" mode, both the lamp and rotation are sound activated. If there is no
sound, the lamp turns off after 5 seconds. There is no difference between the 2
"flash" positions.
F U S E R E P L A C E M E N T
1 Disconnect the fixture from AC power.
2 Remove the fuse holder - located next to the power cord - with a flat-tip
screwdriver.
3 Replace the fuse with one of the same size and rating. The rating is shown on
the serial number label.
4 Replace the fuse holder.
T R O U B L E S H O O T I N G
problem
No light
No action
Fuse blows repeatedly
If these remedies do not solve the problem, contact your Martin dealer for service.
6
probable cause(s)
No power to the fixture
Blown fuse
Burned out lamp
Fixture to hot
Sound too low to activate
control circuit
Electrical malfunction
Electrical malfunction
suggested remedy
Check connections
Replace fuse
Install new lamp
Allow to cool
Improve air flow around fixture
Increase volume
Move speakers closer
Refer to service technician
Refer to service technician
www.audiovias.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wheeler euWheeler ukWheeler us

Table of Contents