Operating Problems And Solutions - Fujitsu DL3100 User Manual

FUJITSU DL3100
The power does not turn on.
The printer is on but it will not
print.
Paper select lever error
8-6

Operating Problems and Solutions

Table 8.3 identifies common operating problems and
suggests solutions.
If you cannot resolve a problem, contact your dealer.
Table 8.3 Operating Problems and Solutions
Problem Solution
Check whether the mains voltage is

correct.
Make sure that the power cord is

securely connected to both the
printer and the mains power outlet.
Make sure that the power outlet is

functional. If not so, use other outlet.
Turn the power off. Wait a minute

and then turn the printer on again. If
the printer still has no power, contact
your dealer.
Verify the printer Online light

condition; If the Online light goes
out, the printer is offline.Press the
Online key can change to Online
state.
If you use the interface cable, make

sure it is securely connected to both
the printer and the computer.
Make sure paper is loaded.

Run the printer Status Page. If

printing executes normally, the
problem is caused by: the interface,
the computer, incorrect printer
settings, or incorrect software
settings.
Make sure that the printer driver

selected in your software is the same
as the emulation selected on the
printer.
If paper is loaded and the paper

select lever is moved to the incorrect
position, the printer turns offline,
and the buzzer sounds continuously.
Switch the paper select lever back to
its correct position.
User's Manual