Fujitsu DL3100 User Manual page 63

FUJITSU DL3100
Paper Setup
Fanfold Left
Mrg (1/90inch)
Fanfold Top
Mrg (1/180inch)
Fanfold Auto
Load
Skip
Tear
Paper End
Detect
User's Manual
Valid Settings
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
Define
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
11, 12, 13, 14, 15, 16, 17, 18,
19, 20, 21, 22, 23, 24, 25, 26,
27, 28
No, Yes
No, Yes
Auto, Manual,
View, Auto@FF
No, Yes
Function
Compensation value added to
Fanfold Left Mrg.
Compensation value added to
Fanfold Top.
Yes: The printer loads paper to the
first printing position automatically
when using fanfold.
No: Press the [Load/Eject] key to
load paper when using fanfold.
Skips printing on perforation area.
Only valid to fanfold.
Yes: Blank lines between 2 pages.
No: No blank lines between 2 pages.
Auto: Form Feed command from the
host causes the printer to advance
the paper to the tear-off position.
Printing resumes on the TOF on next
page.
Manual: After the completion of a
print job, press a panel key to
advance the paper to the tear-off
position.
View: No incoming print data in 1~2
seconds after printing completed
causes the printer to advance the
paper by 2 lines. Printing resumes 2
lines below the torn edge.
Auto@FF: a formfeed command is
necessary to auto feed the form to
tear position.
Yes: The printer stops printing if out
of paper.
No: The printer continues printing
even out of paper.
5-5