Friction Feed Handling - Fujitsu DL3100 User Manual

FUJITSU DL3100
FRICTION FEED
HANDLING
User's Manual
There are 2 paper feed modes: friction feed and tractor
feed.
Raise the single sheet feeder until it locks into its
1.
mounting.
Move the paper select lever forward to " " for friction
2.
feed mode. Make sure that no paper is in the printer
when you switch the paper path.
Adjust the print gap lever if necessary.
3.
Align the left paper guide with the mark on the left of
4.
the single sheet feeder.
Adjust the right paper guide to the width of the paper
5.
used.
Insert a sheet of paper. Make sure that the bottom edge
6.
of the paper engages snugly with the platen. Please push
the paper in manually if the paper does not feed in while
the friction roller is running.
The paper should advance automatically to the print
7.
position. The printer is now ready to print in the online
state.
Attention: In case of aligning the guide to the position in
the figure, the left end starting position is 0 mm. Adjust it to
align to the printing position. Refer to CHAPTER B:
PRINTER AND PAPER SPECIFICATIONS for the print
area.
3-3