Paper Handling Problems And Solutions - Fujitsu DL3100 User Manual

FUJITSU DL3100
Paper cannot be loaded or fed.
Paper jams while loading.
Paper jams while printing.
Paper slips off the forms tractors
or the perforated holes of the
paper tear during printing.
8-4

Paper Handling Problems and Solutions

Table 8.2 describes common paper handling problems and
suggests
Table 8.2 Paper Handling Problems and Solutions
Problem Solution
Make sure that the paper select lever

located on the top right of the
printer is set correctly. Move the
lever to the front for single sheets or
to the rear for continuous forms.
Make sure that the paper covers the

paper-out sensor.
Turn off the printer and remove the

jammed paper. Remove any
obstructions from the paper path.
Make sure that the Print Gap lever is

set for the thickness of your paper.
Make sure that the paper is not

folded, creased, or torn.
Make sure that the left and right

tractors are set so that the
continuous forms are stretched taut.
When using continuous paper, user

must keep the sheed feeder across,
not upright.
Turn off the printer and remove the

jammed paper. Remove any
obstructions from the paper path.
Make sure that the Print Gap lever is

set for the thickness of your paper.
For continuous forms, make sure

that the incoming and outgoing
paper stacks are correctly placed.
Paper should feed straight.
Make sure that the forms tractors

are positioned correctly for the
width of your paper and that the
perforated holes of the paper fit
directly over the tractor pins.
User's Manual