Fujitsu DL3100 User Manual page 169

FUJITSU DL3100
Set initial condition
Format 1BH 5BH 4BH n1 n2 init id parm1 parm2
Function Resets the printer to its initial state according
to the following parameters.
n1 and n2 specify the number of mode bytes in the
escape sequence.
Normally, n1 is 1, 3, or 4 and n2 is always 0. init, id,
parm1, and parm2 are explained below.
init: This parameter specifies which condition the
init=00H;
The printer Condition is initialize to the user default
setting.
The parm bytes overwrite the user default setting.
The download font is not cleared.
init=01H;
The printer Condition is initialized to the user
default setting.
The parm bytes overwrite the user default setting.
The download font is cleared.
init=04H;
The printer Condition is initialized to the factory
default setting.
The parm bytes overwrite the factory default setting.
The download font is not cleared.
init=05H;
The printer Condition is initialized to the factory
default setting.
The parm bytes overwrite the factory default setting.
The download font is cleared.
User's Manual
Function
printer should be initialized to.
The supported values of init are 00H, 01H,04H,
05H, FEH, and FFH.
When the init is any other value, it works as
init=00H.
The following is the basic initial condition for
each init values.
Command
ESC [ K (n1)
(n2) (init)
(id) (parm1)
(parm2)
C-29