Steelcase Think 465 Replacement Manual

Steelcase Think 465 Replacement Manual

Seat and seat slide bearing replacement
Hide thumbs Also See for Think 465:

Advertisement

®
465 Think Chair (New) Seat and
®
Seat Slide Bearing Replacement
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©
2014 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Page 1 of 3
939546540 Rev A
Printed in U.S.A.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Think 465 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Steelcase Think 465

  • Page 1 ® Seat Slide Bearing Replacement If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
  • Page 2 ® Press seat slide handle (at front of seat) and pull seat as far forward as it will go. Tip the chair onto its right side. Locate the seat out stop feature. Insert a screwdriver below the out stop feature and push it (up) toward the seat.
  • Page 3 ® Set chair upright. Locate black seat slide bearings at outer edge of control mechanism. Note that the slide bearings are handed and the thin, short end points forward. Note replacement slide bearings have a small snap on top, inner edge. Unsnap the old slide bearings and pull them off the sides.

Table of Contents