Advertisement
6.
Remove the OLD pivot plate
bearing (6a) and replace it with the
NEW pivot plate bearing (6b).
7.
Place the NEW swing arm link 'A'
and swing arm link 'B' as shown.
8.
Place the NEW plastic washers
into the counterbore holes. Place the
NEW wave washers on top of the
plastic washers. Take the NEW
shoulder bolts (with pre-applied
loctite) and install using a T25 drive
bit with a torque of 50 ±5 in/lbs.
OLD PIVOT PLATE
BEARING
6a
NEW PIVOT PLATE
BEARING
6b
7
NEW SWING ARM LINK
8
NEW PLASTIC
FLAT WASHERS
NOTE: Torque shoulder
screws to 50 ±5 in/lbs.
using a T25 drive bit.
NEW SHOULDER SCREWS
(WITH LOCTITE)
NEW WAVE WASHERS
Page 4 of 6
939546224 Rev B
Advertisement
