Ballard Designs Tuscan MV442 Manual

Cabinet

Download this manual

PRODUCT NAME: Tuscan Cabinet

ITEM NUMBER: MV442

ASSEMBLED DIMENSIONS : 30"H x 36"W x 17 1/8"D

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

UPDATED: 9-11-2020

Prevent accidentally discarding small parts or

hardware. Retain all carton contents until assembly

and installation are complete.

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

IMPORTED

Page 1 of 4

Need help?

Do you have a question about the Tuscan MV442 and is the answer not in the manual?

Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Tuscan Cabinet ITEM NUMBER: MV442 ASSEMBLED DIMENSIONS : 30”H x 36”W x 17 1/8”D Prevent accidentally discarding small parts or hardware. Retain all carton contents until assembly and installation are complete. PRODUCTS ARE NOT INTENDED IMPORTED FOR COMMERCIAL USE.
Page 2 Assemble in location for intended use. Hardware Packet Here REQUIRED TOOLS: Shelf Phillips Screwdriver -Two person assembly suggested. Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean, level, padded surface. Ltr. Qty. Hardware Included Shelf Supports WARNING Wood Plugs...
Page 3 Assemble in location for intended use. SHELVES: Determine placement for Shelf (D) then insert Shelf Supports (A) into corresponding pre-drilled holes. Gently set Shelf level upon Supports. See Fig. 1 Fig. 1 Fig. 2 LEVELERS: If necessary, the Cabinet may be leveled by adjusting LEVELERS located on the bottom of each corner which are accessible INSIDE the Cabinet.
Page 4 WALL ANCHORING HARDWARE (ANTI-TIP) Qty. Hardware Included Small Screw Large Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.