LG WD14070D6 Service Manual page 10

Type-C : Connecting one touch type hose to tap without thread
Ring plate
Guide plate
Step3: Connect hose to washer
After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the
guide plate before inserting the faucet into the adaptor.
1. Unfasten the adapter ring plate and the 4 adapter retaining
2. Remove the guide plate if the tap is too large to fit the
3. Push the adapter onto the end of the tap so that the rubber
4. Pull the connector latch plate down, push the inlet hose onto
Latch plate
• Make sure that the hose is not kinked or crushed.
• The inlet hose with the red connector is for the hot water tap.
• If the washer has two valves, energy is saved by using the hot valve.
Horizontal tap
screws.
adapter.
seal forms a watertight connection.
Tighten the adapter ring plate and the 4 screws.
the adapter, and release the connector latch plate.
Make sure the adapter locks into place.
After connecting inlet hose to water tap, turn on the
water tap to flush out foreign substances (dirt, sand or
sawdust) in the water lines. Let water drain into a
bucket, and check the water temperature.
When your washer has two valves.
Please use the horizontal tap
Extension tap
10
Square tap