Shutting Down - Kärcher BR 47 ESC Manual

 Set the appliance switch to regular
or basic cleaning.
The machine is started.
Note:
The machine switches off when the dirt
water reservoir is full. To restart the
machine, empty the dirt water reservoir
and briefly set the appliance switch to
"0".
 Continue cleaning until the travella-
tor/ escalator has completed 1 or 2
rounds. Then move the machine
towards the side and start a new
cleaning process.
Moving the appliance to the side
 Set the appliance switch to 'dry vac-
uum cleaning' position. Dry vacu-
um cleaning is activated.
 Let the pump pressure fall to 0 bar.
 Set the appliance switch to "0".
 Release the foot pedal.
 Press pedal for raising the brush
head. Brush head is raised.
 Move the appliance to the side.
 Press pedal for lowering the brush
head. The brush head will be low-
ered and the lock lever will arrest in
its position.
 Press the foot pedal and place the
machine centrally in the ridges of
the steps.
 Set the appliance switch to regular
or basic cleaning.
 Then clean using clear water so as
to remove detergent residues.
DANGER
Risk of injury! To refill detergent, al-
ways move out the machine first from
the working position.
12

Shutting down

Complete cleaning
 Set the appliance switch to 'dry vac-
uum cleaning' position. Dry vacu-
um cleaning is activated.
 Let the pump pressure fall to 0 bar.
 Set the appliance switch to "0".
 Release the foot pedal.
 Activate the lever to lock and the
pedal to raise the brush head.
Brush head is raised.
 Release the rear wheels.
 Drive out the machine from the
working position and the podium
until it is on firm ground.
Turn off device
 Pull out the mains plug.
 Drain off and disose the remaining
detergent fluid.
 Drain out the dirt water and dispose
it off.
 Clean the inside and outside of the
machine. Rinse the tanks with clear
water.
 Store the machine in a frost-free
room on an even and clean floor.
 Lock the rear wheels.
 Remove the cordon from the travel-
lator/ escalator only when the entire
working area is dry again. There is
risk of accident on account of slip-
ping even if the travellator/ escala-
tor is slightly moist.
– 10
EN