Figure 31 - Reset-Switch (Hardware Reset) - Leibinger Jet 3 Operating Manual

Group 6
6.7 Other settings and functions
6.7.1 Carry out Hardware Reset
Reset-switch:
Enables the reset of the electronic in case of error. It is placed in the electronic-
cabinet on the main board (controller board).
Figure 31
The hardware reset may only be performed by trained staff!
Do not use any tools for the hardware reset.
Inpropre use of sharp or metallic tools may cause short circuits or other
damages to the circuit board!
A safe way to perform a hardware reset is to unplug the printerfor a
few seconds!
Release R2.0
Operation – Settings and functions
Reset-switch (Hardware Reset)
1
ATTENTION
Page 86
1 – Reset-switch
LEIBINGER JET3