Advertisement
Available languages
Available languages
SIMATIC
IOT Gateway MQTT-Installation Quick Guide
Product Information
Requirements
● The IoT box is connected to the cloud via the "X1 P1 (Cloud)" interface and Internet.
● The IoT box is connected to the system network via the "X2 P1 (Bus)" interface.
● A PC with the Chrome Web browser from which you open the Web interface of the IoT box.
● The PC is connected to the same network as the IoT box.
● The Internet address of the IoT box is 192.168.200.1 (default setting).
● The network mask is set to 255.255.255.0.
● The PC is located in the same subnet the first time it is accessed.
Note
Licensing conditions
The software is stored on the SD card, which may not be removed from the IoT box for licensing reasons. The SD card is
taped over with a seal and secured. Opening the seal is considered a breach of the license agreement.
Call
1. Turn on the PC and the IoT box.
2. Open the Chrome Web browser on the PC.
3. Enter the IP address "192.168.200.1" as the Internet address (default setting, see Requirement).
The PC connects to the IoT box and the Web interface of the IoT box opens.
When accessing the IoT box for the first time, an administrator password must be assigned. This gives you full read and
write access to the settings. With each additional opening of the Web interface, the Maintenance view is opened in read-only
mode.
Reset and Reset-to-Factory
When you press the RESET button, the IoT box restarts.
To reset the box to factory settings (Reset-to-Factory), proceed as follows:
1. Press the RESET button.
2. Then press and hold the USER button.
The USER LED will briefly light up orange and then flash.
3. Keep the USER button pressed until the USER LED goes out. This can take up to 20 seconds.
NOTICE
Data loss
Resetting to factory settings clears all your parameter settings.
When the devices are switched off or the power supply fails, it is not ensured that the adjustable parameters are
transferred correctly. This also applies to unavailability of the Internet (Denial of Service DoS), for example, due to an
overload of the data network or a cyber attack.
Copyright © Siemens AG [2018], and licensors. All rights reserved. Portions include Open Source Software.
See 'ReadMe_OSS.htm' for details.
Siemens AG
Division Digital Factory
Postfach 48 48
90026 NÜRNBERG
GERMANY
A5E46129555
IOT Gateway MQTT-Installation Quick Guide
A5E46129555-AD, 08/2019
Advertisement
