Hyundai DHY6000LE User Manual page 6

First startup
IT IS NECESSARY TO PURGE THE FUEL CIRCUIT
3.1. Preparation before starting up
Put oil on the motor (Fig.1) using 15W40 oil, 1.6Lt maximum, check the
level with the dipstick without screwing it in, the level must remain the
the maximum line (without exceeding the upper mark).
Fill the fuel tank with diesel (Fig 2), with 14 liters (depending on the version).
Connect the red cable to the positive (+) and the black cable to the negative
(-) terminal of the battery. This control is for generator with electric start with
battery.
Turn the ignition key or switch (depending on the version) to the "ON"
position. (Fig 4)
Turn the speed lever to the "RUN" position (Fig 5).
It is possible that the first time you need to purge air from circuit by removing
the rubber tube indicated (Fig.5), letting flow the diesel. When no air, put back
in place, and do not touch the pressure tubes. Repeat if necessary.
3.2 Starting the Generator
Pull the starter until you feel resistance and then let the starter rope to regain
incicial position (Fig 6).
Turn the decompression lever to the starting position (Fig 7).
MAKE SURE THE DIFFERENTIAL IS IN THE "OFF" POSITION.
Turn the key to the START position or pull the starter (depending on the
version) to start the engine (Fig 6).
Try to start no more than 3-4 times. If the engine fails to start, it means that
the purging process has not been respected and that there is still air in the
fuel system. In this case, you must purge again and try start once the air is
purged.
RESPECT THE GENERATOR'S RATED POWER. IF THERE'S AN OVERLOAD THE
BREAKER WILL JUMP BETWEEN 3 AND 10 SECONDS (Fig 8).
Once the generator is running, make it work for 3 minutes and make sure
the differential is at the "OFF" position (down). Then you can connect the
load and put the differential at the "ON" position.
WHEN THE GENERATOR IS RUNNING THE DIGITAL DISPLAY LED 5 WILL
SHOW YOU THE VOLTAGE, FREQUENCY, THE HOURS OF USE AND THE
APPLIED POWER.