Briggs & Stratton TIGER Operation & Assembly Instructions page 6

ASSEMBLY PROCEDURES
Attaching the Upper Handle
ZONE
START
BRACKET
LOWER
HANDLE
Fig. 1
Fig. 2
Grasscatcher
Fig. 1
Fig. 2
6
UPPER
HANDLE
CABLE
TIE
Rear flap
1. Attach the upper handle and the zone start bracket
to the lower handle as shown in figure 1 using the
knobs and bolts provided. The knobs should be on
the outside.
2. Attach the starter cord as shown in figure 2.
3. Secure the throttle cable to the lower handle with
the cable tie to tidy and avoid hanging throttle cable.
STOP the engine before attaching the
upper handle.
Do not over tightening the cable
tie. This may stop the throttle cable
operation. Check the throttle cable
movement before starting.
Fitting the grasscatcher
STOP the engine before fitting or
removing the grasscatcher.
Never use the mower unless the rear
flap is closed or the grass catcher is
correctly fitted.
1. Stop the engine.
2. Raise the rear flap and hook the grass catcher on
the bar at the rear of the mower as shown in figures
1 and 2.
3. To remove the grasscatcher, lift the rear flap and
grasp the handle on the grasscatcher and unhook
from the rear bar.