Cabinet Installation - Kenmore 30 Installation Instructions Manual

KENMORE ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
You may not ground the oven
through the neutral (white) wire if oven is used in
a new branch circuit installation (1996 NEC), mobile
home, recreational vehicle, or where local codes do
not permit grounding through the neutral (white)
wire. When grounding through the neutral (white)
wire is prohibited, you must use a 4-wire power
supply cable. See Figure 4. Failure to heed this
warning may result in electrocution or other
serious personal injury.
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle, or
where local codes DO NOT permit connecting the
appliance cable ground wire to the power supply
cable neutral (white) wire, you must use a 4-wire
power supply cable (see figure 4):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
connect appliance and power supply cable wires as
shown in Figure 4.
Cable from Power Supply
Ground Wire
Red
Wires
Ground Wire
(Bare or Green
Wire)
Junction Box
Cable from appliance
Figure 4 - 4-WIRE GROUNDED JUNCTION BOX
DO NOT ground to a gas supply pipe. DO NOT connect
to electrical power supply until appliance is permanently
grounded. Connect the ground wire before turning on
the power (Figure 4).
If connecting to a 4-wire electrical
system (mobile homes), the appliance frame MUST
NOT be connected to the neutral wire of the 4-wire
electrical system.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than the wire gauge alone.
(and Optional Electric or Gas Cooktop Combination)
White Wire
Black
Wires
White Wire
U.L.-Listed Conduit
Connector (or CSA listed)
Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in
personal injury or damage to the unit.

5. Cabinet Installation

The wall oven can tip when the door
is open. The mounting brackets supplied with the
wall oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Mounting Brackets Installation Instructions
1. Unpack the wall oven. Remove the lower trim taped
on the oven side panel. Find the 2 mounting brackets
and screws included in the literature package.
2. Install the mounting brackets in the wall cabinet as
shown on Figure 5. Note: To prevent damage to
cabinet, it is recommended to drill 1/16" (0.16 cm) dia.
pilot holes before installing the mounting brackets.
F see figure 1
Mounting Brackets
22 3/16" *
(56.4 cm)
F see figure 2
Mounting Brackets
43 5/8" *
(110.8 cm)
* If wood shims are installed please calculate this
dimension from the top of the shim to the middle of
the mounting bracket.
See addendum for anti-tip screws installation
5
at the end of this booklet (if necessary).
Single Wall ovens
H
see figure 1
Double Wall ovens
H
see figure 2
Figure 5