Cabinet Installation; Model And Serial Number - Kenmore 79048173002 Installation Instruction

If
oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreatlonaJ vehicle, or
where local codes DO NOT permit grounding through
the neutral (white) wire, the appliance frame MUST
HOT be connected to the neutral wire of the 4-wire
electrical system. (see figure 4):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires as shown
in Figure 4.
Cable from Power Supply
Ground Wire
_'__ _'_ J_ w w
Red \p____c/_ hite ire
j S
Ground Wire ___'_
(Bare or Green-- _
Wire) J _ ire
Junction Box _ _- .... U.L.-Listed Conduit
_' Connector (or CSA
Cable from appliance listed)
Figure 4
4-WIRE GROUNDED JUNCTION BOX
Model and Serial Number Location
The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a Jot number or letter from the serial plate
on your oven.
Single Wall Oven Serial
Plate Location
Double Wall Oven
Serial Plate Location
5. Cabinet Installation
Do nat lift the the door handle. oven
by
Heavy Weight Hazard
Use 2 or more people to move and install wall oven.
Failure to follow this instruction can result in injury or damage
to the unit.
1. Unpack the wall oven. Remove the bottom trim taped
on the oven side panel.
2. Find the 2 anti-tip mounting screws included in the
literature package.
3. Insert the oven into the cabinet opening. Slide oven
inward leaving 11/2" (3.8cm) clearance between the
oven and front of cabinet (see Figure 5).
cm)
clearance
between unit
Figure 5
4.Pull the armored cable through the hole for it in the
cabinet and toward the junction box while moving the
appliance inward.
5. Push the oven in and against the cabinet.
5