Cabinet Construction; Countertop Preparation - Kenmore c970-440935 Installation Instructions Manual

Hide thumbs Also See for c970-440935:
Table of Contents

Advertisement

Available languages

Available languages

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
1.
Factory Connected Power Supply
Cord
This range is equipped with a factory-connected power
cord (see Figure 1). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician.
Figure 1
2.

Cabinet Construction

2.1
To eliminate the risk of burns or
fire by reaching over heated surface units, do not have
cabinet storage space above the range. If there is cabinet
storage space above range, reduce risk by installing a
range hood that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinet.
2.2

Countertop Preparation

• The cooktop sides of the range fit over the cutout
edge of your countertop.
• If you have a square finish (flat) countertop, no
countertop preparation is required. Cooktop sides lay
directly on edge of countertop.
• Formed front-edged countertops must have molded
edge shaved flat 3/4" (1.9 cm) from each front corner
of opening (Figure 2).
• Tile countertops may need trim cut back 3/4"(1.9 cm)
from each front corner and/or rounded edge flattened
(Figure 2).
Min.
Cutout
Width
¾"
(1.9 cm)
• If the existing cutout width is greater than 30 1/16"
(76,4 cm), reduce the ¾" (1.9 cm) dimension.
• Countertop must be level. Place a level on the
countertop, first side to side, then front to back. If the
countertop is not level, the range will not be level.
The oven must be level for satisfactory baking results.
Cooktop sides of range fit over edges of countertop
opening
5
¾"
(1.9 cm)
31½"
(81 cm)
Formed or tile countertop
trimmed ¾" (1.9 cm) back at
front corners of countertop
opening.
Figure 2

Advertisement

Table of Contents
loading

Table of Contents