*PC tuning
Connect the wires to the PCB in the connector case of
interface cable.
For output the wires out of the connector case, need to
process the connector case.
KPG-36U/36X
Remove the screw
4.6
Radio check Section
Item
Condition
<PC>: PC test mode
<Panel>: Panel tuning mode
1. Frequency
<PC>
check
1) Test Channel: 1
Test Signaling Mode: Analog
Signaling: 1
2) Press [Transmit] button.
<Panel>
1) CH-Sig: 1-1
2) PTT: ON
2. High power
<PC>
check
1) Test Channel: 1
(Battery
Test Signaling Mode: Analog
voltage:7.5V)
Signaling: 1
2) Press [Transmit] button.
1) Test Channel: 2
Test Signaling Mode: Analog
Signaling: 1
2) Press [Transmit] button.
1) Test Channel: 3
Test Signaling Mode: Analog
Signaling: 1
2) Press [Transmit] button.
<Panel>
1) CH-Sig: 1-1
2) PTT: ON
1) CH-Sig: 2-1
2) PTT: ON
1) CH-Sig: 3-1
2) PTT: ON
Connector case
Measurement
f. counter
Power meter
Ammeter
Power meter
Ammeter
PCB layout
8ohm
Shield
Adjustment
Unit Parts
Method
Check an internal temperature of
radio from 20C to 33C.
Check
100 10V
+
AF Voltmeter
100 10V
+
10 10V
+
Audio generator
Specifications
/Remarks
±0.25ppm
±201.5Hz
@806.05MHz
2.5~3.5W
2.3A or less
(No.RA070<Rev.001>)1-39