Kenwood NX-3400 Service Manual page 25

3.2.3 Removing the front case from the chassis
(1) Remove the rear panel with a flat-head screwdriver.
Insert the screwdriver between the rear panel (right side)
and the chassis, push it in the direction of the arrow
<1>,and remove the right side of the rear panel. Repeat the
above action for the left side of the rear panel <2>.
Rear panel
(2) Remove the two screws <3>.
(3) Peel off the void seal.
(4) Lift the base of the chassis and remove the chassis from
the front case. <4>
Note:
• Once the void seal is peeled off, it cannot be used
again.
• When the chassis cannot be removed from the front
case, remove by pushing in the button top with the
finger.
• Regarding VOID, confirm the service policy of the NX-
3400 to KENWOOD (or authorized distributor).
VOID seal
<1>
<2>
<3>
<3>
<4>
3.2.4 Remove the holder ASSY from the chassis
(1) Remove the four tabs on the holder ASSY from the
chassis.<1>
(2) Lift up the holder ASSY, then remove the speaker lead wire
from the connector (CN602).
<1>
<1>
<1>
3.2.5 Removing the Display unit from the chassis
(1) Remove the five screws <1>.
(2) While lifting the Display unit, remove the FPC from the
connector (CN202) of the Display unit.
<1>
<1>
<1>
Display unit
<1>
<1>
Speaker lead wire from
the holder ASSY
CN602 CN602
<1>
FPC
MAIN unit
(No.RA070<Rev.001>)1-25