Key-Lock Setting; Key Click Sound Setting; Band Width Setting For The Temp Ready Signal - SMC Networks HRLE Series Operation Manual

HRX-OM-Z002
Chapter 5 Display and Setting of Various Functions

5.6.2 Key-lock setting

5.6.3 Key click sound setting

5.6.4 Band width setting for the TEMP READY signal

5.6 Setting Menu
5-12
A function to prevent settings from being changed by mistake. Operation can
be started/stopped by operating the [RUN/STOP] key even when the
key-lock has been enabled.
The initial value is "OFF: Key-lock disabled ".
OFF: Key-lock disabled / ON: Key-lock enabled
Make a selection with the [▲] [▼] keys and press the [SEL] key to apply
the setting.
If you try to change a setting with the "▲" or "▼" key while the button-lock
function is enabled, "
cannot change the setting.
PV
SV
The operation sound of the keys when the keys are used can be turned ON
and OFF.
The initial value is "ON: Key operation sound enabled".
OFF: Key operation sound disabled / ON: Key operation sound
enabled
Make a selection with the [▲] [▼] keys and press the [SEL] key to
apply the setting.
This function sets a TEMP READY signal band width for the circulating fluid
temperature (range between the upper and lower limit temperatures) to notify
the user via contact output and serial communication that the circulating fluid
temperature has reached the signal band width in the temperature range set
by the user.
You can set this value in the range of
means a temperature range of ±1.0℃.
The initial value is "1.0" (±1.0℃).
RDY and BAND are displayed alternately.
Change the set temperature with the [▼] or [▲] button.
After changing the value, set it by pressing the [SEL] button.
* The setting blinks while it is being changed.
* If the [SEL] button is not pressed, the value is set to the changed
value after 3 seconds.
" will be displayed for 1 second, and you
PV
SV
±
"0.1 to 10.0℃". Setting this to 1.0℃
HRLE Series