Table of Contents
Advertisement
JEI GroupLtd
17. Mount only annular cutters with the maximum drilling diameter and drilling depth
of 35 mm (1.38'').
18. Using the machine on surfaces that are rusty, covered with a thick paint layer,
uneven, or not stiff is prohibited.
19. Use the safety chain in all operating positions. The chain must not be loose and
must be fastened to a securely fixed element.
20. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
21. Always use eye and hearing protection and protective clothing during operation.
Do not wear loose clothing.
22. The whole surface of the magnetic base bottom must stick to the workpiece.
Before every positioning, wipe the workpiece with coarse-grained sandpaper.
23. Do not touch moving parts or chips formed during milling. Prevent objects from
being caught in moving parts.
24. After every use, remove metal chips and coolant remainder from the machine. Do
not remove chips with bare hands.
25. Maintain the machine and tools with care. Cover steel parts with a thin grease
layer to protect them against rust when not in use for a longer period.
26. Perform maintenance only with the machine unplugged from the supply.
27. Perform repairs only in a service center appointed by the seller.
28. If the machine falls on a hard surface, from height, is wet, or has any other
damage that could affect the technical state of the machine, stop the operation
and immediately send the machine to the service center for inspection and repair.
29. Never leave the machine unattended during operation.
30. Remove from the worksite and store in an isolated and dry location when not in
use, previously removing the cutter from the arbor.
AIRBEAST 35 ATEX Operator's Manual
6
AIRBEAST 35 ATEX
Advertisement
Table of Contents
