Navigation Buttons; Machine Symbol - Vaderstad Rapid Series Instructions Manual

The home screen
E. LowLift/HighLift
Use Low-lift when drilling. This prevents the machine
from being raised too much, while allowing proper
operation of the following harrow in the turning patch.
See the chapter Turning with Low-lift in the user guide
for RD.
A green symbol indicates that the Low-lift function is
switched on.
Note that the machine must never be reversed
while in the Low-lift position!
If it becomes necessary to raise the machine, e.g.
when encountering an obstacle in the bout or to turn
back and fill the seed hopper, be sure to first press
to stop the auto advance feature. Then press
to switch to HighLift. The machine can now be
raised to its maximum height. When the drill is
subsequently returned to the same position as before
the interruption, press Auto advance to re-engage auto
advance of tramlining and bout marker switching, and
the Low-lift position button to return to Low-lift
position.
F. Control function. Enables the adjustment of
drilling depth while driving. Works as a toggle button.
Upon activation, you will have 30 seconds to
manually adjust the depth, to either a higher or lower
value, with the help of a hydraulic cylinder.
AutoPilot turns off automatically when the
Control function is used and must be
activated after adjustment.
G. Auto advance
The normal setting is automatic advance of bout
marker switching and tramlining program. The button
shows a white symbol. This means that the bouts in
the tramlining cycle are advanced and the bout
markers are switched at the completion of each bout.
When auto advance is stopped (green symbol), the
machine can be lifted in a bout without advancing the
tramlining program or switching bout marker.
10
Low-lift position
Auto advance
5.3

Navigation buttons

Home screen. This button always takes
you back to the home screen.
Statistics. Shows statistics of the machine's
operation as well as drilling performance
for the current drilling operation.
Log. Press the button to access the alarms
menu. The alarms menu shows a detailed
description of the nature of the alarm;
alarms can also be acknowledged here. The
number in the top right corner shows the
number of active alarms.
Basic settings and calibration. No settings
in this menu need to be made during
operation.
Information. Press the button to get
information on the status of the Work-
Stations and alarm history.
Electronic operating instructions. This
button takes you to an electronic version of
the machine's user instructions.
Back. The button is on the alarm pages.
5.4

Machine symbol

Figure 5.4
Half machine shut-off
Half machine shut-off is carried out mechanically on the
machine, please refer to the user manual for the machine.
To get the correct area calculation, the half machine shut-
off is confirmed on the IPad by pressing "left" or "right"
under the machine's icon on the home screen.
903099-en-gb; 19.01.2021