Table of Contents
Advertisement
Replacing the lamps
10.3 Replacing the LEDs
Shows the maximum current consumption of
the lamp. A lamp of the same power should be
used when replacing the lamp.
C
To find out the power rating used
in the product, see the declara-
tion label in the product.
Authorized Service Center
If the light fails to function.
• Make sure that the appliance is connected to
the mains and the fuses are not damaged.
• Check the lamps. Make sure you unplugged
the appliance before this check. Tighten bulbs
if unscrewed; you can replace the bulbs if it
still does not work.
11.1 Possible faults and their
troubleshooting before calling
the Technical Service
11.1.1 In case the appliance does not
work at all:
• Check whether the appliance is connected to
the mains or if the plug is properly inserted
in the socket.
• Check the fuse to which the appliance and
home switch are connected.
Fig. 15 Replacing the LEDs
• Push the lamp with your hand to remove it.
• Separate the adhesive band from around the
lamp from the main body plate.
• Before placing the LED lamp, remove the pro-
tection foil from the frame and then replace it
on the product body.
11.1.2 If the device shows low per-
formance or makes a lot of noise while
in use:
• Is the diameter of the exhaust tube adequate?
(min. 120 mm).
• Are the metal filters clean? Check.
• If you use the hood with no exhaust tube,
make sure that the carbon filters are not
older than 6 months.
• Make sure that your kitchen is sufficiently
ventilated in order to ensure the air circula-
tion. In case you are still discontent with the
performance of your appliance, contact the
authorized service unit.
EN
19
Advertisement
Table of Contents
