Introduction; Entering The Calibration/Test Menu - GE CTF878 User & Service Manual

Introduction

Entering the Calibration/
Test Menu
Calibration
For user convenience, the CTF878 offers a Calibration/Test Menu.
This menu enables users to perform a variety of functions that might
occasionally be required to calibrate the CTF878.
Refer to the Service Menu Map, Figure 3-10 on page 3-11, while
moving through the following procedures.
Enter the Service Menu as described on page 1-1, then select the
Calibrate/Test option. The screen appears similar to Figure 3-1 below.
Site Program
Velocity, m/s
15.38
Units
Corr SNR
0
Figure 3-1: Calibrate/Test Menu
To scroll to a particular option, press the [
you reach the option. Then press
When entering parameters in an option, press:
•
the [ ] key to step through the available parameters.
•
the [ ] key to scroll back to a previously entered parameter.
•
[F2]
the key (Cancel) or the
and return to Operate Mode without changing the parameters.
Service
Meter Logging
Diagnostics
Signal Setup
Test
Error Limits
Test
Factory Defaults
Flash Update
Calibrate / Test
Main Board (0)
34
AnalogIns (2)
Digital Outputs (3)
RTDs (4)
50 10
RTDs (5)
] or [
[ENTER]
to open the option window.
[ESC]
key to exit an option at any time
February 2009
] arrow keys until
3-1