Adding Printers In Netware - Axis 5550 User Manual

Adding Printers in NetWare

Section 6
46
Adding Printers in NetWare
This section describes how to continue the installation of the AXIS
5500/AXIS 5550 in the NetWare environment. Identify which transport
protocol you are running on your network and which installation method
you should use. Continue the installation by selecting the appropriate
installing instructions from the table below:
Installation Transport
method protocol
TCP/IP
NDPS
IPX/SPX
iPrint over LPR
iPrint
iPrint over IPP
IPX/SPX
Basic
Configuration
Queue-based
printing
IPX/SPX
Advanced
configuration
See "NetWare Administration" on page 71 for information on Novell's
administration tools.
If you intend to operate your AXIS 5500/AXIS 5550 in a multi-protocol,
mixed environment, you should also proceed to the other relevant
sections in this manual.
Action
See "Setup using NDPS" on page 47,
"Public Access Printers" on page 47 and
"Controlled Access Printers" on page 51
See "Setup using iPrint" on page 61 and
"Install a printer using AXIS LPR Gateway Configuration Snap-
in" on page 63
See "Setup using iPrint" on page 61and
"Install a printer with AXIS IPP Gateway Configuration Snap-in"
on page 63
To install using the AXIS NetPilot Installation Wizard,
see "Basic Setup with AXIS NetPilot" on page 65.
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard,
see "Advanced Installation using AXIS NetPilot" on page 67.
AXIS 5500 / AXIS 5550 User's Manual